StageSense is currently in development and not yet available.
Overview & SitesPowerLighting & MAConsole DiagnosticsNetworkAlerts & NotificationsBlackbox & ReportsWeb App & PhoneServer, Client & Bridge

Features

Alerts & Notifications

One problem list for everything, push to your phone, resolved with duration, show mode and maintenance.

Screenshots show the app in German with demo data; English screenshots follow with version 1.4.

One problem list for everything

Anything unusual from power, lighting, network and services becomes a problem with severity, start and end – from disaster via high, average and warning to info. How bad a failure is depends on whether it hits the show: a device that is delivering show data right now weighs more than the same device without.

An alert is sent only once a condition lasts long enough, and resolved only after a recovery time – so nothing flaps. Acknowledge one or all, with a note, in the web app too.

Problems in the manual (German)

Alerts on the phone: two open problems with OK button, a blackbox capture and the events with warning, resolved and infoOverview on the phone: two open problems, show mode active, power, network, lighting and services as tiles
Alerts and overview on the phone · demo data

Push to your phone

Every alert takes the same routes – notification on the Mac, web push to the iPhone, plus ntfy, Pushover, Telegram and webhook. New alerts are collected for 10 seconds, consequences of another failure are dropped.

🔴 🟠 ✅ ℹ️

Alarm, warning, resolved and info – consistent in every notification. The title names level and device, e.g. “🔴 Alarm – DC 3 UV 1”, the text below says what is going on.

Resolved with duration New in 1.3.5

Every resolved message carries the duration: “reachable again after 10 s”, from 2 minutes “after 3 min”, from one hour “after 1 h 20 min”.

No silent ending New in 1.3.5

Every reported problem ends with a message and a reason. If a problem merges into a bigger one, its ending comes with that one’s resolved message.

Push pause New in 1.3.5

If notifications don’t reach the phone, StageSense warns on the Mac and in the web app. Afterwards a summary notification brings everything that happened during the pause.

Show mode

During the show the Mac stays quiet – no sounds, no notifications. Push to the phone keeps going, so the people in charge know immediately.

Maintenance

For load-in, load-out or changeovers: globally or per device for 1, 2 or 4 hours or until tomorrow morning. Problems are still recorded but not reported.

Event log

Every alert with time and source. After show mode it lists what the Mac kept quiet in the meantime.